Drill template for imperial measures with tilting mechanism. Remove bottom guide template, then drill up to 1-1/2" diameter
For auger bit length up to 18" (457 mm)
This is a shorter version of our SwissPRO BST 460 drill guide, which can be used with auger bits up to 24" long.
- can be tilted from 0 - 45° (with scale);
- drill hole guides: from 1/4" to 1.0"
- depth stop;
- high precision, polished guide shaft;
- good view of drill center;
- drill clamp diameter 43 mm (Euronorm); CAUTION: Always use drill motor with built-in safety clutch
- ~10 lbs (4.6 kg) weight, without drill.
- Optional side fence.
(Drill not included)
Here is our SwissPRO drill guide in use with a Doublecut Auger, re-building the Bartonsville Covered Bridge, in Rockingham, VT, after it was destroyed during Hurricane Irene in 2011. Over 2000 holes @1-1/8 and 1-1/4 inch, were drilled with our Doublecut auger, and countersunk with Zobo System 3 bit.
For best and most efficient drilling results, see our Double Cut Augers below.
